1 / 3
Nose Pad for Glasses
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I couldn't remove the screw of the nose pad, so this design goes around the screw and fits inside the housing firmly.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 144
- Wydruki
- 0
- Wyświetlenia
- 847
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (10)Powiązane
I couldn't remove the screw of the nose pad, so this design goes around the screw and fits inside the housing firmly.
I've changed my settings a bit for this one.
- I would advise you to increase the retraction distance a little bit, slow down if you are printing fast normally, and set the layer height to 0.12 mm.
- The gap will probably get a very thin layer of stringing. Try to cut that in between with a utility knife or a razor. If you don't have stringing, then it's good! But if you have, try to trim it a little bit so the screw can fit in between. Be gentle because the walls are thin and can break if you apply too much force.
- Then push the nose pad into the hole just a little bit, and then switch to pliers and push the rest of it. I advise you to use pliers because your hands might slip and you can break the walls inside of the housing.
I've failed 3 times but then it worked like a charm! Don't be discouraged if you can't get it right the first time. It's a very small part, so some trial and error is normal.
I've also uploaded the .step and .prt files if you like to change them for your needs.
Happy printing!