Corner Bed Locator for Anycubic Kobra 2 Max w/ cable management
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
To help locate the PEI sheet and keep the bed power cable from going under the bed.
- Ocena
- 5 / 5
- Polubienia
- 92
- Pobrania
- 836
- Wydruki
- 1
- Wyświetlenia
- 3616
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
It is not easy to locate the bed on a 420x420 machine. I have designed this locator to fit the Anycubic Kobra 2 Max.
Note: 2 models the difference is the clearance on the side to the gantry/motor. Some machines require a narrow model which is the 2mm version.
I replaced the screws for the cable harness with M3x25mm flat head screws replacing the 16mm long screws. Then I used nuts and washers to attached. Then 2 zip ties to secure the power cable to the bed. I added a 15% lift to the cable to help prevent the cable from getting wrapped under the machine.
Warning: Test mount, make sure the locator clears the motors on the upright of the machine. If the bed is offset to much it will not clear.
Printed from PETG, 6 walls, 25% infill.