BIFRC spot welder snap fit case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a snapfit case for the BIFRC spot welder. No mouting screws are required. The case is a tight fit, without…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 125
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a snapfit case for the BIFRC spot welder. No mouting screws are required. The case is a tight fit, without visible gap between the case and the lid. There is a button and a hole for the LED.
I used a bit of hotglue to cover the hole for the LED so the light from the LED will lightup through the semi transparant hotglue (if you don't use to much ;) )
The pcb doesn't rattle inside the case as it is kept tighly in its position.
Print Settings
Printer Brand:
Ultimaker
Printer:
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
25%
Filament: Colorfabb PLA Black & Red
Notes:
I used Cura to slice the model and used tree support as it is easier to remove than the traditional support and also uses less material
Category: Electronics