1 / 7
generic camera screw adapter for SV07 webcam mount (1/4"x20)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapter for thing:6308788 SV07 Camera Mount allowing cameras/webcams that are fit with a 1/4x20 thread to be…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 350
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
An adapter for thing:6308788 SV07 Camera Mount allowing cameras/webcams that are fit with a 1/4x20 thread to be mounted onto the Y belt tensioner of the Sovol SV07. All parts are printable without supports, and no additional metal parts are needed!
Printing suggestions:
- print the screw vertically with 4 perimeters (walls) and 0.1 mm layer height
- print 3-4 washers to have on hand in case the screw hole on your camera is too shallow
- print the adapter upside down as shown in the 2nd photo (wide base down)
Assembly:
- First, pass the screw through the washers and the adapter and screw it into the camera.
- The adapter is sized to fit the belt tensioner mount by friction alone (may require some force to assemble).The mount isn't square! so try rotating it 90° if it doesn't want to go in before you open the swear jar. if the fit is too loose add 4 drops of CA superglue at the 4 corners of the adapter before assembling.
Category: 3D Printer Accessories