Dovetail Stacking Marker Tray
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dovetail Stacking marker tray for Stampin Up or similar markers. Print as many levels as you need!
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 110
- Wydruki
- 0
- Wyświetlenia
- 471
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
Stacking marker tray with sliding dovetails to lock them together.
Designed for Stampin Up markers, but would fit anything up to about 12mm - 13mm in diameter.
There's an open base included to use as a riser, or you could use a combination of marker and hollow for a unique case.
Print the stacking trays vertical. Depending on your bed adhesion, you may want to include a brim to avoid warping. Print the lid top-down for the best print quality on top.
I printed at .3mm with a .4mm nozzle in PLA and the dovetails are a snug fit, so not necessarily something you would be able to take apart easily. Depending on your printer resolution and print quality, you may need to run a knife or sandpaper along the edges to get a sliding fit that you can move back and forth. I used a combination of deburring tool, Olfa knife and a triangle needle file for clean-up and it only took a few minutes to get a nice sliding fit.
If you print this model, please post a make!
Thanks
Mike