Ninebot F2 Pro/Plus (D) Holder Kettenhalter Schlosshalter (3cm chain-Ø)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple way to attach and store a 3cm chain to the upper part (super convenient to use!) for the new Ninebot F2 eScooter
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 71
- Wydruki
- 0
- Wyświetlenia
- 973
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Please leave a ♥ Like if this print was helpful to you :-)
This is a "clamp-on" design chain holder for the Ninebot F2 Pro/Plus/… (D) escooter and has a max chain width of 3 cm. Holds the lock securely in place when not needed and also makes locking it on somewhere much easier. Additionally, it blocks the dashboard screws from being unscrewed, which is often a tactic used by thieves to steal the scooter.
Similar Models I made:
You need:
- PC Blend or ASA to print for outdoor durability (if intended to use during winter)
- 4 x M4x20 screws
- 4 x M4 nuts (or nylocs)
- Loctite (optional)
A good assortment to get started is something like this.
Print Settings
- Rafts: No
- Supports: Yes
- Resolution: 0.2mm
- Infill: 30
- Filament: Prusament PC Blend
Depending on your printer supports below the ring that holds the chain might make sense. Choose the infill to your liking, I would recommend at least 20 % - but going beyond 50 % probably doesn't make any sense either.