1 / 1
Ninebot F2 Pro/Plus (D) Holder Kettenhalter Schlosshalter (3cm chain-Ø) — image 1

Ninebot F2 Pro/Plus (D) Holder Kettenhalter Schlosshalter (3cm chain-Ø)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple way to attach and store a 3cm chain to the upper part (super convenient to use!) for the new Ninebot F2 eScooter

Rating
0 / 5
Likes
4
Downloads
71
Makes
0
Views
973
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial

Please leave a ♥ Like if this print was helpful to you :-) 

This is a "clamp-on" design chain holder for the Ninebot F2 Pro/Plus/… (D) escooter and has a max chain width of 3 cm. Holds the lock securely in place when not needed and also makes locking it on somewhere much easier. Additionally, it blocks the dashboard screws from being unscrewed, which is often a tactic used by thieves to steal the scooter.

Similar Models I made:

You need:

  • PC Blend or ASA to print for outdoor durability (if intended to use during winter)
  • 4 x M4x20 screws
  • 4 x M4 nuts (or nylocs)
  • Loctite (optional)

A good assortment to get started is something like this.

Print Settings

  • Rafts: No
  • Supports: Yes
  • Resolution: 0.2mm
  • Infill: 30
  • Filament: Prusament PC Blend

Depending on your printer supports below the ring that holds the chain might make sense. Choose the infill to your liking, I would recommend at least 20 % - but going beyond 50 % probably doesn't make any sense either.

Tags