another universal bike phone holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
another universal bike phone holder
- Ocena
- 0 / 5
- Polubienia
- 32
- Pobrania
- 162
- Wydruki
- 1
- Wyświetlenia
- 1227
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
I don't know why I obsessed with phone holder for bike, not satisfied with my previous design yet, so I make another one. this is shorter than previous design and using m3 knob and 3mm rod.
for knob assembly, m3 headless screw max length I found is 35mm, if you can't get m3 headless screw and m3 nylon locknut, use regular screw with regular m3 nut, and use thread locker(red loctite) or super glue to glue the screw and nut. If you have long m3 thumbscrew you can skip the knob and use m3 thumbscrew.
for mounting on handlebar, use single screw top clamp, the 3 screw used for stem raiser mounting.
Total weight 55gram, weight may vary according what variant you print and the hardware you choose.
make a comment for any issue and post a make if you like it.
BOM:
- 3mm smooth rod/shaft any material will do.
- 1pcs m3 nylon lock-nut (you can use m3 regular nut, but use thread locker or super glue)
- m3x50 screw or m3x35 headless screw(if using m3x50 cut the head with grinder)
- 6pcs m3x10 screw
- 3-6 pcs 3mm heatset insert OD 4.2 height max 5mm
- 2pcs m4 nut
- 2 pcs m4x10-15 screw (depend where you mount it to)
- 3mm-4mm ID spring or silicon spacer (optional, prevent rattling when used without phone)
Use strong filament like ABS/ASA, but PLA will do. 0.3 layer height. no support required.
print orientation:
