PrusaTeleStrat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
remixed the Prusacaster to fit Stratocaster parts i had an old strat laying around and wanted to give it new life
- Ocena
- 5 / 5
- Polubienia
- 46
- Pobrania
- 116
- Wydruki
- 1
- Wyświetlenia
- 1057
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial
I remixed the Prusacaster to fit Stratocaster parts because i had an old cheap Strat laying around and wanted to breath new life into it. this took quite a while so consider supporting me via https://www.buymeacoffee.com/imasra
IMPORTANT:BRIDGE HOLES COULD BE OFF BY A COUPLE OF MM DEPENDING ON YOU NECK ETC. USE A SOLDERING IRON TO BURN NEW HOLES IF THIS IS THE CASE disclaimer this is the way i did it and so far after a few months its holding up strong
there are 2 versions of the body one split in two which needs 4xpeg_long and 1xpeg_small and a ton of superglue also i used 12perimeters to be on the safe side
the other version is for people with a bigger build volume its all one piece i use 10 perimeters because of the added hole in the back making it thinner
also it is normal that you might need to sand the spot for the neck to fit this is so you can have as snug of a fit as possible i have not changed the size of the cavity from the original
both are printed in PLA with organic paint on supports a brim of 10mm 25% gyroid infill
