1 / 3
Ender 5s1 LGXPRO with Revo Six hotend — zdjęcie 1
1 / 3

Ender 5s1 LGXPRO with Revo Six hotend

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Take that Ender 5s1 one more step further by adding the Bondtech LGX Pro with a revo six

Ocena
0 / 5
Polubienia
8
Pobrania
28
Wydruki
0
Wyświetlenia
675
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is to use the LGX PRO and the Creality Revo Six. I have it installed and testing. The LGX PRO is heavier and larger then the stock extruder.  I went with the pro for a couple reason 1. it can handle higher temps as I have mine fully enclosed and print mostly abs/asa. 2. I have the ercf on my 5s1 using no toolhead sensor. the 5s1 started to not like the collision of the filament against extruder gears.

you will need to print the new fan duct. With the LGX being larger, i had to move the extruder carriage back 5mm, so I adjusted the fan duct to match.

 You will need to go in to the config and adjust the safe home by adding 5mm to the safe home. 

you will notice there is a inset with 2 holes on the front. they are for future additions I'm working on. 1 a filament sensor (testing hall effect vs switch vs optical. lots to test). The a filament cutter using a raspi controlled servo. 

Let me know if you would like any other extruders or hotends. 

Tagi