Koru Spiral Earring
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ear spiral insert loosely based on a traditional Maori stylistic form. Parametric, but default will fit 9mm piercings.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 533
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- GNU General Public License v3.0
Ear spiral insert loosely based on a traditional Maori stylistic form. This one will fit 9mm piercings, but the SCAD file is parametric and the object can be scaled by +/- 30% without problems.
Instructions
This particular one was printed in an experimental bronzed PLA in the Diamond Age Solutions workshop. We printed it with a 3mm brim and no support.
After printing, peel off the brim and any loose bits. Flame-polish with a small, blue, flame, and if desired bend slightly to adjust the plane of the tail.
If you wish, you can slip a rubber ‘O’-ring over the point once it is in your ear and push it along the spiral to the point where it stops the spiral rotating out of your piercing.
Note:
3D Printing has progressed since this design was created. There is one with a smoother surface (and much higher poly count) here.