Koru Spiral Earring
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ear spiral insert loosely based on a traditional Maori stylistic form. Parametric, but default will fit 9mm piercings.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 70
- Makes
- 0
- Views
- 533
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Fashion Accessories
- License
- GNU General Public License v3.0
Ear spiral insert loosely based on a traditional Maori stylistic form. This one will fit 9mm piercings, but the SCAD file is parametric and the object can be scaled by +/- 30% without problems.
Instructions
This particular one was printed in an experimental bronzed PLA in the Diamond Age Solutions workshop. We printed it with a 3mm brim and no support.
After printing, peel off the brim and any loose bits. Flame-polish with a small, blue, flame, and if desired bend slightly to adjust the plane of the tail.
If you wish, you can slip a rubber ‘O’-ring over the point once it is in your ear and push it along the spiral to the point where it stops the spiral rotating out of your piercing.
Note:
3D Printing has progressed since this design was created. There is one with a smoother surface (and much higher poly count) here.