1 / 6
Ham Radio IC-7300  3-Level stand w/ memory card holder — zdjęcie 1
1 / 6

Ham Radio IC-7300 3-Level stand w/ memory card holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3 - Level High Stand for IC-7300 and similar models. Holds SD & Micro SD cards.

Ocena
5 / 5
Polubienia
27
Pobrania
200
Wydruki
2
Wyświetlenia
1450
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I was using a piece of a 2x4 for holding up my radio at the right height. I decided to make a 3D printed stand with different height's so others could adjust them to their view. I sometimes record the audio and the radio settings, so with SD cards laying around, I added storage for holding them in close proximity to the radio.

I used Cura 5.4 to print with and FreeCAD to design it. 

Stand is printed bottom down with supports.

The card holder insert, prints with the holes up, also using supports.

If you prefer, the card holder can be turned around so the large pocket is on the left.

 

Layer height  - 0.2mm 

Wall line width - 0.4

Wall order - Outside to Inside

Infill - 15%

Support - Tree

Filament - Sunlu PLA @ 215c

 

Tagi