Lolin ESP32 S3 Mini Slim Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a slim case for the Lolin ESP32 S3 Mini
- Ocena
- 3 / 5
- Polubienia
- 8
- Pobrania
- 194
- Wydruki
- 1
- Wyświetlenia
- 1532
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a slim case for the Lolin ESP32 S3 Mini
Board is roughly 25.5mm wide and 34.5mm deep. It fits nice and snug.
Note: these are smaller than the D1 mini boards
It has a hole for the LED and for the reset button. The program button is covered.
It clips together with a bit of force. Its a bit tough to reopen once clipped together.
Two versions. One has a extra large deep recess for USB (That is the one I printed in the photos) I recommend the standard version.
I printed this with PETG on my MK3 at 0.20 (quality) with a fill of 20%. I'm sure PLA would work fine too.
Give me a shout if you successfully print it.