1 / 3
Altoid tin cover thing and insert to hold my things — zdjęcie 1
1 / 3

Altoid tin cover thing and insert to hold my things

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

it's in red so it's hard to see but it's the little lid cover and the easier to see insert for all my printing stuff

Ocena
0 / 5
Polubienia
4
Pobrania
26
Wydruki
0
Wyświetlenia
755
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

I sized up the insert by 102.25% and printed it in TPU, it fits like so perfectly that to show off how proud I am of it fitting so well I keep shaking the tin at people when I show them and I think it is safe to say it's not coming out in one piece if I ever change my mind. I didn't size up the actual model just the one in my slicer my paranoia says if I size up the model for everyone it won't fit, I would recommend printing just a layer or two of it and see if it fits how you want, I would recommend printing it in TPU if you also want no sliding around.

There's also a little block that fits in the SD card slot so I can have room for more SD cards if I decide I need more later and don't need to take the whole thing out.

 

The lid bumper thing fits without resizing since I didn't actively plan on messing it up because of how well the insides went just prior, I would still recommend testing it out a bit if you want it snug enough to not need glue. This also stays on its own better and makes the lid quieter when printed in TPU but I had tested it out a bit in PLA and it would work just fine with glue.

The hinges on mine were a bit off center and I don't have any other altoid tins than this random old one I found that doesn't appear to have a sell by date so who knows how old it is so the spots for the hinges might not line up well on other tins so I made a shorter version that shouldn't run into any hinges unless they're higher than on my tin.

Tagi