Altoid tin cover thing and insert to hold my things
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
it's in red so it's hard to see but it's the little lid cover and the easier to see insert for all my printing stuff
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 26
- Makes
- 0
- Views
- 755
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
I sized up the insert by 102.25% and printed it in TPU, it fits like so perfectly that to show off how proud I am of it fitting so well I keep shaking the tin at people when I show them and I think it is safe to say it's not coming out in one piece if I ever change my mind. I didn't size up the actual model just the one in my slicer my paranoia says if I size up the model for everyone it won't fit, I would recommend printing just a layer or two of it and see if it fits how you want, I would recommend printing it in TPU if you also want no sliding around.
There's also a little block that fits in the SD card slot so I can have room for more SD cards if I decide I need more later and don't need to take the whole thing out.
The lid bumper thing fits without resizing since I didn't actively plan on messing it up because of how well the insides went just prior, I would still recommend testing it out a bit if you want it snug enough to not need glue. This also stays on its own better and makes the lid quieter when printed in TPU but I had tested it out a bit in PLA and it would work just fine with glue.
The hinges on mine were a bit off center and I don't have any other altoid tins than this random old one I found that doesn't appear to have a sell by date so who knows how old it is so the spots for the hinges might not line up well on other tins so I made a shorter version that shouldn't run into any hinges unless they're higher than on my tin.