1 / 2
Lead screw cover with recoverable any thickness magnets for X1C/P1P/P1S — zdjęcie 1
1 / 2

Lead screw cover with recoverable any thickness magnets for X1C/P1P/P1S

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Any thickness 6mm or 8mm magnets. The magnets can easily be removed/recoverable.

Ocena
5 / 5
Polubienia
18
Pobrania
148
Wydruki
1
Wyświetlenia
1195
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a remix of the lead screw shield by chiz.

I modified 4 things:

  1. Magnets are now easily recoverable as oppose to inserting/gluing them into a tight fit hole.
    1. The magnets are now inserted from the outside, so it allows for any reasonably thickness.
    2. There is now a thin layer of plastic at the contact surface.  Effectively, the magnets can easily be recovered if the part is no longer desired.  Simply push the magnets back out – destroying the thin plastic layer if necessary.
  2. Shaved 0.5mm off the cover surface.  From 1.5mm to 1.0mm.
    1. The original design had a 1.5mm thick shell, which I find is uncomfortable with my P1S print plate.  I shaved this shell down to 1.0mm, which fits and has a nice gap.
  3. Added a 6mm magnets variant
    1. In addition to the original 8mm magnets variant
  4. Removed the built in support
    1. I use paint on support where support is necessary

NOTE: Do not add support to inside the magnet holes.