120VAC Outlet Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I've spent over a HALF ROLL of filament to get this to work! This is my famous snapfit recessed style outlet holder! I…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 92
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
I've spent over a HALF ROLL of filament to get this to work! This is my famous snapfit recessed style outlet holder! I did put a little super glue along the edge of the inner as pictured to strengthen the bond! I would say you shouldn't have too. But if you do at least wait dry time like hours to a full day. I almost gave up on this and to say that it was designed to be put in sheet metal. It was VERY HARD to get a structural bond to hold this in place especially testing pulling the plug out and not pulling out the socket with wires! Maybe my most difficult design I had over had todo in my life! because the amount of waste produced and printing soo many fails that were soooo close. Then all of a sudden YANK! This NEW DESIGN PREVENTS ALL THAT!
Used in Raspberry Pi IoT https://www.thingiverse.com/thing:4992092
Check out my NEW IEC snap-in mount! https://www.thingiverse.com/thing:6010302
Category: Electronics