120VAC Outlet Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I've spent over a HALF ROLL of filament to get this to work! This is my famous snapfit recessed style outlet holder! I…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 17
- Makes
- 0
- Views
- 92
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I've spent over a HALF ROLL of filament to get this to work! This is my famous snapfit recessed style outlet holder! I did put a little super glue along the edge of the inner as pictured to strengthen the bond! I would say you shouldn't have too. But if you do at least wait dry time like hours to a full day. I almost gave up on this and to say that it was designed to be put in sheet metal. It was VERY HARD to get a structural bond to hold this in place especially testing pulling the plug out and not pulling out the socket with wires! Maybe my most difficult design I had over had todo in my life! because the amount of waste produced and printing soo many fails that were soooo close. Then all of a sudden YANK! This NEW DESIGN PREVENTS ALL THAT!
Used in Raspberry Pi IoT https://www.thingiverse.com/thing:4992092
Check out my NEW IEC snap-in mount! https://www.thingiverse.com/thing:6010302
Category: Electronics