1 Channel Relay Module Mount Snug & Snap fit versions
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
!!!(Ver8 is Snap Fit Ver7 slightly loose but can work)!!! This is for a Relay Module with dimensions: L 43.78mm x W…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 268
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
!!!*(Ver8 is Snap Fit Ver7 slightly loose but can work)*!!!
This is for a Relay Module with dimensions: L 43.78mm x W 26.28mm
Stand-Off's are hole ready! (No drilling Necessary!!!)
Snug Fit and flush mount
I also made this so that it can fit ~ 6mm Length screws. (board mount)
Lightweight & Strong Base Support!
This is my First Project since my Printer has been "Dialed In"!!!
(Detailed Prints without hairs and flat,aligned,clean)
As long as the bed is level EVERY TIME!
I used Fusion 360 to design this project. Then my slicing software is slic3r currently. I keep my settings low. Then you get a strong durable part!
I hope you guys enjoy and use this!
On Adafruit Show & Tell January 27/2016 https://www.youtube.com/watch?v=03kcbBZcsLg
2 Channel Relay Mount: http://www.thingiverse.com/thing:1285305
4 Channel Relay Mount: http://www.thingiverse.com/thing:1287530
8 Channel Relay Mount: https://www.thingiverse.com/thing:4992420
Print Settings
Printer Brand:
RepRap
Printer:
Geeetech Prusa i3 X
Rafts:
No
Supports:
No
Infill:
80%
Notes:
Print Time: 101 Minutes
Extruder: 225 Bed: 75 PLA >>> GLUE STICK
Layers: 81 Layer Height: 100 microns Extrusion Width: .5mm
Infill: 3D Honeycomb Outter/Inner: Hilbert's Curve
4mm Brim Skirt 1
Weight: 6.6g
Category: Electronics