1 Channel Relay Module Mount Snug & Snap fit versions
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
!!!(Ver8 is Snap Fit Ver7 slightly loose but can work)!!! This is for a Relay Module with dimensions: L 43.78mm x W…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 48
- Makes
- 0
- Views
- 269
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
!!!*(Ver8 is Snap Fit Ver7 slightly loose but can work)*!!!
This is for a Relay Module with dimensions: L 43.78mm x W 26.28mm
Stand-Off's are hole ready! (No drilling Necessary!!!)
Snug Fit and flush mount
I also made this so that it can fit ~ 6mm Length screws. (board mount)
Lightweight & Strong Base Support!
This is my First Project since my Printer has been "Dialed In"!!!
(Detailed Prints without hairs and flat,aligned,clean)
As long as the bed is level EVERY TIME!
I used Fusion 360 to design this project. Then my slicing software is slic3r currently. I keep my settings low. Then you get a strong durable part!
I hope you guys enjoy and use this!
On Adafruit Show & Tell January 27/2016 https://www.youtube.com/watch?v=03kcbBZcsLg
2 Channel Relay Mount: http://www.thingiverse.com/thing:1285305
4 Channel Relay Mount: http://www.thingiverse.com/thing:1287530
8 Channel Relay Mount: https://www.thingiverse.com/thing:4992420
Print Settings
Printer Brand:
RepRap
Printer:
Geeetech Prusa i3 X
Rafts:
No
Supports:
No
Infill:
80%
Notes:
Print Time: 101 Minutes
Extruder: 225 Bed: 75 PLA >>> GLUE STICK
Layers: 81 Layer Height: 100 microns Extrusion Width: .5mm
Infill: 3D Honeycomb Outter/Inner: Hilbert's Curve
4mm Brim Skirt 1
Weight: 6.6g
Category: Electronics