E-flite Apprentice STS Cowl
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 3D printed replacement cowl for an E-flite Apprentice STS of S15E
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 243
- Wydruki
- 0
- Wyświetlenia
- 787
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I found this on Thingiverse, and thought that I should upload it here.
"Found out what the range was on my transmitter unfortunately and crashed my Apprentice STS. Never liked the stock cowl design so I came up with this.
Use a 10% infill for supports without support roof. Change support angle to 70degrees to avoid unnecessary supports. Cut out for the front wheel with scissors. For locating the holes I used black sharpie around the holes on the fuselage so that I could see them through the cowl, marked the locations and then drilled. Flight tested and no issues. I think it looks better than the original, let me know what you think.
Happy flying!"
Thank you, 3doodler72 for this design.