E-flite Apprentice STS Cowl
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a 3D printed replacement cowl for an E-flite Apprentice STS of S15E
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 243
- Makes
- 0
- Views
- 787
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
I found this on Thingiverse, and thought that I should upload it here.
"Found out what the range was on my transmitter unfortunately and crashed my Apprentice STS. Never liked the stock cowl design so I came up with this.
Use a 10% infill for supports without support roof. Change support angle to 70degrees to avoid unnecessary supports. Cut out for the front wheel with scissors. For locating the holes I used black sharpie around the holes on the fuselage so that I could see them through the cowl, marked the locations and then drilled. Flight tested and no issues. I think it looks better than the original, let me know what you think.
Happy flying!"
Thank you, 3doodler72 for this design.