HSW Mountable Case for ESP32-C3 SuperMini and LD2410C
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of my case for the ESP32-C3 SuperMini and LD2410C that is HSW mountable.
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 130
- Wydruki
- 1
- Wyświetlenia
- 2227
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Please comment, rate, and post a make!
A simple case for using an LD2410C radar sensors with an ESP32 C3 Mini that can be mounted to the HSW. I've included a little spacer that can be slid over the pins of the LD2410C to help with soldering to the ESP board.
BOM (affiliate links):
- ESP32-C3 SuperMini
- LD2410C Radar Sensor
- USB Cable
I use these short and these long cables. - Something to mount them to the wall with:
- My preference is Gorilla Putty but a small Command strip should work just as well.
Prints require no supports. I've used PLA without issue.
- Snip off the “out” pin on the LD2410C. This is the middle pin.
- Slide the space over the pins.
- Solder the pins to the ESP board.
- The VCC pin on the LD2410C goes into the 5V hole on the ESP. The rest of the pins fall in line.
- See the photos for reference
- Cut off the excess from the pins.
- Slide the boards into the case.
- You'll need to slide the LD2410C in first at a slight angle.
- Pop the cover into place.
I'm using this YAML config on these with Home Assistant and they're currently my favorite presence sensor.
Will require a blank insert to attach to the HSW.
Be sure to check out my other models!