Filament Guide for 20x20 extrusion.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Filament Guide for 20x20 extrusion. Will fit any printer with a 20x20 top Rail.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 169
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
Filament Guide for 20x20 extrusion.
I had recently converted my ender 3 Pro with an inexpensive direct drive kit and noticed that the filament would unspool on the Roller Spool holder I was already using. The addition of a filament guild to prevent this is based on the new Filament Guild on the Pruse Mark IV.
I didn't see any guilds I liked, and thought I could come up with something using Tinkercad.
There are 4 Versions, each uses the same base design of a Boll and socked that will hold a small piece of PTFE tube to help prevent the filament form over spooling. I finally chose the 4th version as it put the guild closest to the spool and would not impede the movement if the printer was reaching it Maximum height on a print.
Version 3 and 4 will require the addition of 2 - M3x8 screws and 2 - 3MM T Nuts. This give the most secure contention for the Guide. Version 1 and 2 simply slide into the 20x20 extrusion, but tend to slide back and forth while printing.