Filament Guide for 20x20 extrusion.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Filament Guide for 20x20 extrusion. Will fit any printer with a 20x20 top Rail.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 35
- Makes
- 0
- Views
- 169
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
Filament Guide for 20x20 extrusion.
I had recently converted my ender 3 Pro with an inexpensive direct drive kit and noticed that the filament would unspool on the Roller Spool holder I was already using. The addition of a filament guild to prevent this is based on the new Filament Guild on the Pruse Mark IV.
I didn't see any guilds I liked, and thought I could come up with something using Tinkercad.
There are 4 Versions, each uses the same base design of a Boll and socked that will hold a small piece of PTFE tube to help prevent the filament form over spooling. I finally chose the 4th version as it put the guild closest to the spool and would not impede the movement if the printer was reaching it Maximum height on a print.
Version 3 and 4 will require the addition of 2 - M3x8 screws and 2 - 3MM T Nuts. This give the most secure contention for the Guide. Version 1 and 2 simply slide into the 20x20 extrusion, but tend to slide back and forth while printing.