1 / 5
Filament Cutter 45°
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Filament cutter with 45° cutting angle. Spring mechanism for easy return. Construction from commonly available parts.
- Ocena
- 4,866 / 5
- Polubienia
- 12 895
- Pobrania
- 22 163
- Wydruki
- 845
- Wyświetlenia
- 177 005
- Oceny
- 716
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 845) (Komentarze: 1023)Remiksy (50)Kolekcje (16 700)Powiązane
- No supports needed.
- Tested with PETG and PLA.
Material
- 2 pieces of screw M3 x 25 mm
- 2 pieces of ball pen spring (probably 20 mm length, 4 mm diameter, M3 screw must fit inside)
Assembly Instructions
Check video instructions here.
- Print both parts.
- Take one piece of snap-off blade and put it into upper part. Use some pliers to avoid an injury. There is a small mark near blade pocket which shows you where the tip of the blade should be. Additionally you can use super glue to fix it in position.
- Put both screws into the holes.
- Put ball pen springs into the holes.
- Place the upper part on the main body and press it fully.
- Tighten the screws. Screw head should be about 1,5 mm inside head holes. If you will tight them too much it will destroy plate at the upper part.
- Release upper part and check if blade is not visible inside the filament hole. If yes loose the screws little bit.
- I recommend to put some lubricant inside to keep the mechanism running smoothly.
Acessories
Here you can find nice box from Wapameepto.