1 / 5
Filament Cutter 45°
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Filament cutter with 45° cutting angle. Spring mechanism for easy return. Construction from commonly available parts.
- Rating
- 4.866 / 5
- Likes
- 12,895
- Downloads
- 22,163
- Makes
- 845
- Views
- 177,005
- Reviews
- 716
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
DetailsFiles (6)Makes & comments (Makes: 845) (Comments: 1,023)Remixes (50)Collections (16,700)Related
- No supports needed.
- Tested with PETG and PLA.
Material
- 2 pieces of screw M3 x 25 mm
- 2 pieces of ball pen spring (probably 20 mm length, 4 mm diameter, M3 screw must fit inside)
Assembly Instructions
Check video instructions here.
- Print both parts.
- Take one piece of snap-off blade and put it into upper part. Use some pliers to avoid an injury. There is a small mark near blade pocket which shows you where the tip of the blade should be. Additionally you can use super glue to fix it in position.
- Put both screws into the holes.
- Put ball pen springs into the holes.
- Place the upper part on the main body and press it fully.
- Tighten the screws. Screw head should be about 1,5 mm inside head holes. If you will tight them too much it will destroy plate at the upper part.
- Release upper part and check if blade is not visible inside the filament hole. If yes loose the screws little bit.
- I recommend to put some lubricant inside to keep the mechanism running smoothly.
Acessories
Here you can find nice box from Wapameepto.