ESP32-C3 "supermini" case for simple led strip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple case for the Esp32-C3 "supermini" that can be attached somewhere with double sided tape.
- Ocena
- 4,667 / 5
- Polubienia
- 39
- Pobrania
- 340
- Wydruki
- 4
- Wyświetlenia
- 2316
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Public Domain
Simple case for the Esp32-C3 "supermini" that can be attached somewhere with double sided tape.
The plug that locks the ESP32 inside has a small opening for led strip wiring - this is what I used it for. It can be fixed in place with a M3 countersunk screw, but it will likely work fine without too, depending on your printer tolerances. The FreeCAD file is included in case you need to modify it.
Printing
Should print fine without supports, just orient the shell vertically with the usb port hole at bottom, and use a brim if you have trouble with prints not sticking well.
Attribution
The ESP32-C3 board 3D-model was created by Hans Wurst.