MicroSwiss NG extruder mount for Voron 2.4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed a custom mount for the MicroSwiss NG extruder kit to fit on to the linear rails and belts of a Voron 2.4.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 92
- Wydruki
- 0
- Wyświetlenia
- 1034
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I designed a custom mount for the MicroSwiss NG extruder kit to fit on to the linear rails and belts of a Voron 2.4.
There is also a BLTouch mount in here but I personally think it might hold the sensor a little low. I may redesign it in the future but you could space it up with a few washers if you need.
This will reduce your x axis movement a bit so be sure to check.
I use sensor less homing so I have no idea if the homing switches on other printers will line up.
I printed at 100 infill in ABS for rigidity. Not sure it matters but that's what I did.
I also used a different fan shroud to allow for the use of the larger 5015 part cooling fan. The fan shrouds from microswiss are interchangeable. You can find the one I used here. https://www.thingiverse.com/thing:5874750
Make sure to check the picture specifying where the threaded inserts go. There are other holes to allow space for other screws and the screw holes for the mount to the linear rail.