FloatEx - FLSUN QQS-Pro Floating Extruder

Floatex - the zero weight floating extruder mount for Flsun QQS-Pro Printer

The Stepper Mount is made for the original extruder stepper but it should fit with other as well. With the slot you can adjust the string to the center for the best level between stepper and extruder. I now use floatex with my new Quattro Bearing Carriage (https://www.thingiverse.com/thing:4669014) but other spring holding carriages work as well, as the original carriage + some rubberbands as you could see on the pic ;)

And yes i know it could be a easier design but i like it that way :P No just kidding please let me know if there are any problems, as this is my second selfmade design. I insert a small piece of bowden tube to guide the filament threw the nut, its not necessary but maybe better - for this the hole is a bit tiny so i put a drill in, by hand. i will make it a bit bigger when i am less lazy :D, maybe you found some other changes till then.

608-ZZ 8mm Bearings are used for the pulleys. You can use M8 screws or print them.

1x Counterweight Holder
1x Counterweight Nut
1x Counterweight Screw
1x Nema17 Stepper Mount
3x M8 Nut
3x M8 Screw
3x Pulley

Print Settings

• Printer:FLSUN QQS-Pro
• Rafts:No
• Supports:Yes
• Resolution:I printed all 0.2 but 0.3 should be good as well, except the screw+bolt
• Infill:30%
• Filament brand:whats at home
• Filament color:Yes
• Filament material:PLA / stiff material