Voron Trident RSCS mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE: Because of the stop-switches, I can only turn on the fans after certain height, otherwise, they will blow the bed sideways.
I am not ready to go sensorless but this model has plenty of room to extend if you decide to do so.
I have the LDO Trident 300 ( 300x300x300) and the original design is a little bit too short.
I remixed it to fit my printer specs while allowing adjustments from the original design without crashing with the X/Y endstop.
I am yet to wire and test it but this is out of the scope.
For the sake of practicality and in case the original design gets deleted ( It has happened before with the Mandalorian design I re-uploaded), I am uploading all the untouched files from the original post.
All the credits goes to Mard0