Bluepill case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple sleeve case for bluepill stm32F103 mini dev kit. There is availablesource on-shape url so you can…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 73
- Wydruki
- 0
- Wyświetlenia
- 471
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a simple sleeve case for bluepill stm32F103 mini dev kit. There is available source on-shape url so you can edit if you like.
The bluepill, at least in my experience, comes in version with 1.2mm and 1.6mm pcb so 2 different STL's are available. You can easily create any pcb thickness you like, just edit the variable (only one available) in the source and export new stl.
Print Settings
Printer:
my own build
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.3
Notes:
you can print this from 0.1mm till 0.35mm layer height and it will work. thinner the layer better the letters on the back come out but I personally print this between 0.3 and 0.35mm, 70mm/sec to get them to print faster as I don't care too much about how it looks as long as it performs the required task. I printed these in ABS but any material should work as long as it's non-conductive.
I print this with brim, so it gets better adhesion to bed since it's small area touching the bed and a tall print and then I leave the brim that closes the "rails" so on one side the slider is kinda closed.. anyhow printing without brim works too.
I print at least 2 of then in the same time to solve the heat accumulation problem
Category: Electronics