Barrina (6 Pack) LED T5 Integrated Single Fixture Switch Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick model to mount the switch to a wall or wall stud
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 367
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a way to mount the light switch for this LED light setup in my basement. This is my solution. The switch has a concave back and it kept slipping when trying to mount it flat. This design has a arch so that you can use a thin section on double sticky back tape or other solution you prefer. The switch will need to be in the downward position to slide it into the case. It will make sense once you fit the switch into the model.
I have made some improvements on the model that are not shown in the picture. I made the access port for the switch more rounded and made the screw holes the perfect size for (2) #6 drywall or other screws to mount to bare studs or a flat wall etc.
Printed in PLA with the stock generic .30 speed profile with a .4 nozzle . Printed on a Prusa Mk3s. If your printer is dialed in you can print it on the back or side and will not need supports. I needed supports. I was not looking for quality with this print. Your slicer settings will make it look a lot better
Here is the link for the light set which I highly recommend. https://www.amazon.com/Barrina-Integrated-Fixture-Utility-Ceiling/dp/B07PG3RLH7/ref=sr_1_5?crid=10HK3B4TXWZP1&keywords=Barrina%2B(6%2BPack)%2BLED%2BT5%2BIntegrated%2BSingle%2BFixture%2BSwitch%2BMount&qid=1702491298&sprefix=barrina%2B6%2Bpack%2Bled%2Bt5%2Bintegrated%2Bsingle%2Bfixture%2Bswitch%2Bmount%2Caps%2C190&sr=8-5&th=1
Please share and remix.