1 / 2
Vacuum Roller Belt Replacement for Bissell P/N 3031120
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple replacement belt that interchanges with Bissel Part Number 3031120 that can be printed in TPE/TPU.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 315
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Public Domain
Scale up/down as needed!
Simple replacement belt that interchanges with Bissel Part Number 3031120 that can be printed in TPE/TPU. This belt is a little thicker than the original, FreeCAD file included if you would like to adjust.
Printed with eSUN TPE-83a, TPU may also work but you may need to increase the size of the belt slightly to get it to stretch enough to install the roller.
Installation:
- Remove the green bottom cover by removing the metal screws including the 2 at the front corners where the side brushes are.
- Remove the roller and old belt, clean the brushes out if they are clogged up at all.
- Slide the new belt over the motor shaft at the opposite end of the bottom of the vacuum from the Roller you removed (it's a thin metal shaft). You'll have to try to angle it around it by pushing, a screwdriver or similar may help here but be careful not to puncture or tear the belt.
- With the roller still removed, slip the belt over where it rides.
- You will need to pull with a decent amount of force to get the roller to seat, it should almost snap into place once you pull it enough while trying to guide it inward.
- Roll the roller back and forth a few times to ensure that the belt is centered.
- Re-attach the bottom cover and turn the vacuum on, the roller should now spin while the vacuum is not moving.