Glass Separation Riser with or without Venting - 12mm LED Strip (No AMS)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix to allow 12mm wide RGBW LEDs. Two versions: with and without glass holder for venting. No AMS support.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 802
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This remix allows for RGBW LED strips which are typically 12mm wide. Up to 12.5mm wide strips should work. Direct line-of-sight to the LEDs through the top glass is prevented. SpectreGadget's original design for holding the glass up for venting is nice and this one is very similar. I've also included a version without the elevated glass holder.
There are recesses at the corners to help accommodate bending a single LED strip. I chose to cut and solder mine. Support is required for the LED mounting surface--a compromise I felt worthwhile for a more optimal lighting angle and efficient hiding of the LEDs. Tolerance on the connector fittings is 0.9mm. Snug but workable fit for me printed with PETG at 0.2mm on a P1S.
You'll need the left front and right front parts, along with both parts labeled VENT or both labeled NO VENT. The wire hole plug goes with both models and helps keep the power cable in place but isn't necessary.