2023-2024 Toyota Integrated Front Windshield Mount for Dashcam/GoPro/Devices
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Securely mount your dashcam and other devices in the front windshield of your Toyota using the stock mirror bracket.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 1308
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Standard Digital File License
Mount a dashcam or electronics in your Toyota vehicle's front windshield using only the stock mirror bracket.
No suction cups or drilling required! This mount securely attaches directly to the existing bracket built into windshield.
The modular device attachment point fits all devices with a common GoPro style mount. A blank universal mount is provided for customization for your device needs.
If you power your device from the vehicle fuse box using a fuse tap, you may find the free Power Distribution Fuse Box Extended Cover useful for covering the fuse box if the original fuse cover is too low and no longer fits.
Printing:
- No supports required.
- 100% infill.
- Printing in PC/PETG/ABS recommended for hot climates. PLA may work in colder climates.
Compatibility:
- Fits all 2023 and newer vehicles with Toyota Safety Sense (TSS) 3.0. The compatible vehicles' front module looks like the below:
- Confirmed fit on 2023 Toyota Corolla Cross Hybrid.
- Confirmed fit on Toyota vehicles using Toyota Mirror Cover Part Numbers 864660A070 and 8640116010.
Mounting:
Parts needed:
| Quantity | Part |
|---|---|
| 1 | M5 x 16mm bolt |
| 1 | M5 x 18mm bolt (16-20mm length recommended) |
| 2 | M5 nuts |
Steps:
- Print the Mount Arm, Nut Holder, and any device specific adapters with GoPro style attachment.
- Pre-thread the Nut Holder hole for M5 bolts by screwing and unscrewing an M5 bolt in the Nut Holder hole.
- Fit the device specific adapter into the Mount Arm modular mount.
- Place a M5 nut in the hexagonal hole located on the passenger side of the modular mount.
- Insert a M5 x 18mm bolt through the driver side of the modular mount and tighten it into the M5 nut on the opposite side.
Remove the upper interior rear view mirror cover.
- Bend the rear view mirror down for more space.
- Hold the upper outside edge of the upper (smaller) cover and slowly pull down towards the ground to unclasp the two clips on the left and right of the cover.
- Slide the rear view mirror cover out.
- Place a M5 nut in the hexagonal hole on the back of the Nut Holder.
- Slide the printed Nut Holder with the hexagonal hole facing the windshield into the empty bracket on the driver's side of the rear mirror mount.
- Place the Mount Arm over the front of the bracket with the oval hole lining up with the hole in the bracket.
- Insert a M5 x 16mm bolt through the Mount Arm front oval hole and gently but firmly tighten it into the Nut Holder. 16mm is the maximum recommended length for this bolt!
- Mount your device to the adapter.
- Replace the upper interior rear view mirror cover. Re-adjust the rear view mirror.
