1 / 5
IKEA PAX holder for Skadis board
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Screwless base plates (L+R) fitting inside 3 PAX holes and 2 matching hooks for the skadis board.
- Ocena
- 5 / 5
- Polubienia
- 48
- Pobrania
- 162
- Wydruki
- 2
- Wyświetlenia
- 1121
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (0)Kolekcje (101)Powiązane
This IKEA Skadis mount fits into a IKEA PAX wardrobe.
I wanted a screwless model. In order to cope with the weight, I used 3 holes per base. (I did not do any load test).
I used the following settings for printing on my 0.4mm nozzle
- Extrusion width : 0.6mm (I assume 0.4mm works fine, too)
- Layer hight : 0.28mm (I assume 0.2mm works fine, too)
- Walls : 5
- Top+Bottom : 3
- Infill : Gyroid 15%
- Enable support (build plate only)
- Filament : PLA+
Assembly:
- Push the hooks into the (top outer) slots on the Skadis board, “in and up” (it's a tight fit)
- Slide the bases (marked L and R) onto the hook's dovetail
- Push the base parts into the PAX holes (I started with the one further inside)
- Adjust the Skadis board horizontally by sliding left/right in the dovetail