Logitech C270 Improved Wide angle Lens Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I updated CO-OCD's great design for the Logitech C270 by adding threads and air vents. After I started printing…
- Ocena
- 5 / 5
- Polubienia
- 67
- Pobrania
- 354
- Wydruki
- 8
- Wyświetlenia
- 3770
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I updated CO-OCD's great design for the Logitech C270 by adding threads and air vents. After I started printing polycarbonate in my enclosure at around 38C ambient my entire C270 setup started warping. See the last 2 photos for the warping of my original parts.
This could be due to two reasons:
- I used HTPLA which the ambient + camera might overheat so I reprinted in PETG
The camera generates a lot of internal heat so I added air vents to the case Additionally with the weight of the wide angle lens I could no longer trust the push fit design, so I added threads to both ends of the wide angle lens mount. This is much more secure.
You will need to get a focus ring from another design upload. I use this one: https://www.thingiverse.com/thing:3088614
Category: 3D Printer Accessories