ESP32 Webradio Housing With Knurled Dial
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the housing I made for my ESP32 webradio project. It consists of three seperately printable parts which…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 284
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is the housing I made for my ESP32 webradio project. It consists of three seperately printable parts which require minimal to no support.
Print the front and rear plate faceing down and the main body on its end.
Here's the link to the accompanying Instructable: https://www.instructables.com/Wood-and-3D-Printed-ESP32-Webradio/
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0.2 mm
Infill:
10-20%
Filament: Filamentworld PLA Black
Post-Printing =============
Add Veneer
I added walnut veneer to the front and back plate of my print using CA glue. Check out my Instructable for more details.
Category: Electronics