Humidity Sensor Holder for Sunlu S1 Filament Dryer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
supportless sensor holder for the Sunlu S1
- Ocena
- 4,929 / 5
- Polubienia
- 119
- Pobrania
- 585
- Wydruki
- 16
- Wyświetlenia
- 4098
- Oceny
- 14
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I like the idea of varstef75's sensor holder, however the curved hanger is unnecessary thick and the sensor frame is a bit too small. So, I redesigned it from scratch, using half of this holder instead, which should fit the sensor easier due to the small holes on the sides.
I made this with no support in mind, so the top hole has a single sacrificial layer. Simply use a craft knife to remove it. Refer to the included photo for print orientation.
To attach to the dryer, I used a M5x10 nylon screw and bolt. You can purchase it from Amazon or print it yourself.
Print instructions
- Printer: Prusa MINI+
- Rafts/Supports: No
- Resolution: 0.2mm
- Infill: 30%
- Filament: PLA/PETG