Humidity Sensor Holder for Sunlu S1 Filament Dryer
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.81 – €2.21 net (excluding VAT)
For file: improved-sensor-holder-sunlu-v5-no-support_0.2mm_PETG_MINI_2h21m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.01 excluding VAT (range midpoint).
- Weight reported by the author
- 19 g
- Print time reported by the author
- 2.36 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
supportless sensor holder for the Sunlu S1
- Rating
- 4.929 / 5
- Likes
- 119
- Downloads
- 585
- Makes
- 16
- Views
- 4,104
- Reviews
- 14
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
I like the idea of varstef75's sensor holder, however the curved hanger is unnecessary thick and the sensor frame is a bit too small. So, I redesigned it from scratch, using half of this holder instead, which should fit the sensor easier due to the small holes on the sides.
I made this with no support in mind, so the top hole has a single sacrificial layer. Simply use a craft knife to remove it. Refer to the included photo for print orientation.
To attach to the dryer, I used a M5x10 nylon screw and bolt. You can purchase it from Amazon or print it yourself.
Print instructions
- Printer: Prusa MINI+
- Rafts/Supports: No
- Resolution: 0.2mm
- Infill: 30%
- Filament: PLA/PETG