1 / 4
Origami Folding Car w/ Suspension
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
With a few folds, turn this into a racer with a working suspension!
- Ocena
- 5 / 5
- Polubienia
- 69
- Pobrania
- 203
- Wydruki
- 2
- Wyświetlenia
- 1691
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (7)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (0)Kolekcje (67)Powiązane
Print easily in one flat sheet, and then fold into a pint-sized racer!
- No Supports
- Utilize a filament swap ~layer 20 for custom seat/engine color
- Compliant Mechanism suspension
Instructions
- Fold the green lines slightly up. To do this without accidentally folding the yellow lines, use your scraper to hold the rest of the car down to the table. (see video)
- Now fold the yellow lines 90 degrees, allowing the wheel holders to go down.
- Fold the red lines to form the hood, tucking the back of the hood cutout under the notch by the engine.
- Fold the blue lines to form the back, using the clips to attach around the car's windows.
- Hold an axel upright against the table. Press a wheel down onto the top.
- Slide axel through wheel holes and then press the other wheel on. (Note - if your wheels press in too far, you can print new axels that are stretched slightly longer)
Troubleshooting
| Issue | Solution |
|---|---|
| Fold lines break | Avoid old, brittle filament. Only fold one time (don't go back and forth) |
| Axel won't go into wheel | Press really firmly while supporting the axle against the table. Otherwise, you may need to adjust your slicer's horizontal expansion setting. |
| Wheels are touching the body of the car and won't spin. | Re-print axels which should take 1 minute. In your slicer, stretch them slightly longer. |