1 / 4
Deep Counterbore T300RS and G29 pedal to Playseat Mounts — zdjęcie 1
1 / 4

Deep Counterbore T300RS and G29 pedal to Playseat Mounts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Basically the same as the original by @Elod_HU, but the screwhole is a deep counterbore.

Ocena
0 / 5
Polubienia
10
Pobrania
102
Wydruki
0
Wyświetlenia
490
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Public Domain

This remix features a deep counterbore hole for the holders.

Same as the original, this is fast to print and easy to install. You'll need four M6 screws and eight zip ties.

 

Works for Thrustmaster T300RS and Logitech G29 on the Playseat Challenge.

 

Print Instructions

AnkerMake M5C prints 1 piece in roughly 20 minutes with the settings below.
You can print all 4 at the same time (circa 1 hour 30 minutes)

Print them as shown in the 2nd Screenshot.

Nozzle: 0.4mm
Material: PLA / PLA+
Layer Height: 0.28mm
Perimeters: 2
Supports: “Snug”
Support Top Z Distance: 0.2mm
Infill Density: 50%
Infill Pattern: Rectalinear
 

Tagi