Deep Counterbore T300RS and G29 pedal to Playseat Mounts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Basically the same as the original by @Elod_HU, but the screwhole is a deep counterbore.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 102
- Makes
- 0
- Views
- 491
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Public Domain
This remix features a deep counterbore hole for the holders.
Same as the original, this is fast to print and easy to install. You'll need four M6 screws and eight zip ties.
Works for Thrustmaster T300RS and Logitech G29 on the Playseat Challenge.
Print Instructions
AnkerMake M5C prints 1 piece in roughly 20 minutes with the settings below.
You can print all 4 at the same time (circa 1 hour 30 minutes)
Print them as shown in the 2nd Screenshot.
Nozzle: 0.4mm
Material: PLA / PLA+
Layer Height: 0.28mm
Perimeters: 2
Supports: “Snug”
Support Top Z Distance: 0.2mm
Infill Density: 50%
Infill Pattern: Rectalinear