Bombardier Traxter Front cargo cover latch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The original front cover latches for the Bombardier Traxter are no longer available where I live. I made replacements
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 285
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- GNU General Public License v2.0
I couldn't find any replacement rubber latches for my Bombardier Traxter so I made a set of these out of Sunlu 95A TPU. These stretch just enough to work on my machine using that TPU. I made some wavy bits to allow a little better stretch. Time will tell if these hold up.
I printed with 0.4mm nozzle, .25 layer height, 25% infill and 2 perimeters. They appear to hold the lid down well. The small shoulder that locks in above the body panel is a little tough to get through the hole so I needed to push it up with a pry bar from below while pulling from the top to get it to engage fully.
I hope it works for anyone else who had the same problem.