Bombardier Traxter Front cargo cover latch
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The original front cover latches for the Bombardier Traxter are no longer available where I live. I made replacements
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 42
- Makes
- 0
- Views
- 282
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- GNU General Public License v2.0
I couldn't find any replacement rubber latches for my Bombardier Traxter so I made a set of these out of Sunlu 95A TPU. These stretch just enough to work on my machine using that TPU. I made some wavy bits to allow a little better stretch. Time will tell if these hold up.
I printed with 0.4mm nozzle, .25 layer height, 25% infill and 2 perimeters. They appear to hold the lid down well. The small shoulder that locks in above the body panel is a little tough to get through the hole so I needed to push it up with a pry bar from below while pulling from the top to get it to engage fully.
I hope it works for anyone else who had the same problem.