Xfinity Battery to Panasonic Skin (emulating EY9231 battery)

Xfinity Battery to Panasonic Skin (emulating EY9231 battery) 
 

Here is an adaptor to use an Aldi Xfinity battery to emulate a Panasonic EY9231 battery

** note you will be overvolting your tool **

Extra requirements

2 x 6mm male spade connectors
2 x 6mm piggyback terminals 

4 x M3 nuts
4 x M3 10mm socket head bolts
2 x wires
2 small zip ties

40mm long, 5mm diameter, 0.5 gauge spring

https://www.aliexpress.com/item/4000282581926.html

https://www.aliexpress.com/item/4000253156130.html

https://www.aliexpress.com/item/4000404713325.html

https://www.aliexpress.com/item/1005002536637698.html

https://www.aliexpress.com/item/1005004081326463.html

Assembly Guide

I find if I run a 3mm drill bit through all the bolt holes, it helps with getting the bolts in smoothly.

Remove the insulation from the spade terminals and install one on one end of each wire and feed it through the holes in the base plate, matching the polarity. Use some pliers to push the terminals in for the last few millimeters, they should fit nice and snug.

Load the nuts into the base plate.

Load the spring and buttons into the top plate, then feed the wires into their respective holes inside to the top of the male Ryobi section, then screw down the top plate to the base plate whilst ensuring the wires are pulled through to minimise slack inside the adaptor.

Cut the excess wire exiting the top and install the piggyback terminals.  Secure the piggyback terminals in position with the zip ties to the mounting post.

I can adapt to other slide in style batteries, just let me know and I can probably make it.

If you like this model, please throw me a like.  Designing the models is time, filament and coffee consuming. If you want to support my work buy me a coffee (PayPal). Thanks!