1 / 4
Oral-B Pro 1000 Charger Pad Saver-Spacer
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cheap print for Easy Clean up of your Oral-B Pro 1000 charger
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 176
- Wydruki
- 3
- Wyświetlenia
- 705
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 3) (Komentarze: 5)Remiksy (0)Kolekcje (39)Powiązane
I don't know about you, but my Oral-B Pro 1000 charger gets nasty and nasty fast! It's a pain to clean once it's gotten to that point.
I've created a thin plastic film to put in the middle to help make this process ultra fast!
- Cost about a penny or two to make!
- Less then 4 minutes to print!
- Has a pull tab for easy removal!
- Tiny spacer to let a little bit of air flow in under the brush if you want (2 versions).
Suggested printing setup:
- Suggest using PETG or ABS for it's water resistance over PLA.
- Smooth Side Down printing.
- Suggest setting Bottom Surface Pattern as Concentric to help better seal water away.
- Let it cool down before taking it off the build plate. Very thin print (1mm-2mm).
It's a little tight when you put it on, but that's by design. Adds a better seal to the part that sticks up. Plastic is thin so it might be a little tight, but it'll go one pretty easy.
Enjoy!