1 / 4
Oral-B Pro 1000 Charger Pad Saver-Spacer — image 1
1 / 4

Oral-B Pro 1000 Charger Pad Saver-Spacer

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Cheap print for Easy Clean up of your Oral-B Pro 1000 charger

Rating
5 / 5
Likes
24
Downloads
176
Makes
3
Views
705
Reviews
4

Updated at source:

Model information

Category
Bathroom
License
Creative Commons — Attribution — Noncommercial

I don't know about you, but my Oral-B Pro 1000 charger gets nasty and nasty fast!  It's a pain to clean once it's gotten to that point.  

I've created a thin plastic film to put in the middle to help make this process ultra fast!  

  • Cost about a penny or two to make!
  • Less then 4 minutes to print!  
  • Has a pull tab for easy removal!
  • Tiny spacer to let a little bit of air flow in under the brush if you want (2 versions). 

Suggested printing setup:

  • Suggest using PETG or ABS for it's water resistance over PLA.
  • Smooth Side Down printing.
  • Suggest setting Bottom Surface Pattern as Concentric to help better seal water away.
  • Let it cool down before taking it off the build plate.  Very thin print (1mm-2mm).

It's a little tight when you put it on, but that's by design.  Adds a better seal to the part that sticks up.  Plastic is thin so it might be a little tight, but it'll go one pretty easy.

Enjoy!

Tags